Get up to $600 cash back
Don’t let energy slip through the cracks
Be wattsmart and save on duct sealing and duct insulation. When energy is lost through duct surfaces, heating and cooling equipment has to work harder to make up for the loss. As a result, you could be spending too much money to maintain comfort. Duct sealing and duct insulation can cut those heating and cooling costs by 30 percent.
Qualifications & Incentives
|Duct sealing (stand alone)||$300|
|Duct sealing and duct insulation||$600|
Ensure the home qualifies:
- Must be an existing home, not new construction
- Work completed must comply with all building codes and standards
- Must have a minimum of 10 linear feet of exposed ductwork located in unconditioned space
- Home's primary heat source must be either a ducted heat pump or an electric forced air furnance
- Existing ducts must be unsealed
Requirements for both duct sealing (stand alone) and duct sealing and duct insulation:
- Work must be completed by a Program-Qualified HVAC Contractor listed on the Program-Eligible HVAC Contractors List. Please review our tips for hiring a contractor
- Work must be completed in accordance with the specifications outlined in the Wyoming Technical Specifications Manual
- All physically accessible ducts located in unconditioned spaces must be sealed
- Duct sealing must reduce duct leakage to the outside by 50 percent or more with a 100 CFM (Cubic Foot per Minute) minimum reduction
- A functioning carbon monoxide alarm is required when a combustion appliance is present within the confines of the structure
Additional requirements for duct sealing and duct insulation:
- Pre-existing duct insulation levels may not exceed R-2 and must be replaced with at least R-8
- All physically accessible ducts located in unconditioned living spaces must be insulated
- Duct sealing and duct insulation must be performed in the same project, with insulation installed after ducts are sealed
- For customers applying for multifamily properities, please contact the program at [email protected] for details on how to apply
Additional program rules:
- Home may qualify for either duct sealing or duct sealing + insulation, but not both
- Incentives are limited to one-time installations within the qualified space of the home and cannot exceed the total cost of the project
- Homes that have previously received an incentive through the program do not qualify for additional incentives if replaced
- When applying for duct sealing + duct insulation, separate contractors may perform the two services. The duct sealing contractor listed on the application will receive the trade ally incentive
- Submit all documents so they are received within 90 days of the qualifying service completion date
- Duct Sealing and Duct Insulation Application, completed and signed
- Itemized receipt or contractor invoice
- Third Party Payment Addendum for applicants who would like to forward payment to a third party not listed on the utility account
- IRS W-9 Form, if applicable*
*Applicable only to businesses and non-individual customers, including landlords, applying for incentives
Electric heating is defined as a permanently installed, ducted system consisting of an electric furnace or heat pump serving as the home's current primary heat source
Electric cooling is defined as a permanently installed, ducted electric central air conditioner or heat pump serving as the home's current primary cooling source. Room air conditioners and evaporative coolers do not qualify
Non-Electric heating or cooling is defined as a heating or cooling system with gas, oil, wood heating, pellet stoves, or propane serving as the home's current primary heating or cooling source
Conditioned vs. unconditioned space - clarification notes:
For the most part, basements are conditioned spaces. Basements are not usually thermally isolated from the main living area and contain space conditioning ducts. Basements are also used for storage and frequently contain laundry facilities and other living spaces. Ducts serving unfinished basements are not always equipped with dedicated supply registers, although single registers at plenums are not unusual.
An unconditioned basement would have these properties: Thermally isolated from the main floor by insulation in the floor. Insulated, weather-stripped door (if above floor plane) and insulated stairwell walls where thermal plane penetrates floor, air sealed (caulked, foamed penetrations) wiring plumbing, sealed duct penetrations and sealed, insulated ducts. No supply registers.
While a crawl space is unconditioned space, the floor must be insulated prior to or at the same time ducts are sealed and insulated to thermally isolate the crawlspace. Failure to do this will increase the heating load of the home and potentially cause comfort issues.
Please see the Incentive Application for a complete list of all required documentation. Incentives and qualifications are subject to Wyoming Public Service Commission approval. Additional terms and conditions may apply.
Residential electric customers residing in the state of Wyoming who purchase their electricity from Rocky Mountain Power on rate schedules 2 or 18 qualify. Landlords who own rental properties served by the company in the state of Wyoming where the tenant is billed on rate schedules 2 or 18 also qualify for this program. You can locate your rate schedule on your bill or by calling 1-888-221-7070. Incentive checks are only issued in the name of the Rocky Mountain Power accountholder.
How to Apply
Prior to starting a project, find a contractor using the Wyoming Program-Eligible HVAC Contractors List. Note that select incentives must be completed by a Qualified Contractor (a contractor with specialized certifications). Review the incentive application with your contractor to determine eligibility requirements, incentive qualifications and review the list of required documents to submit for an incentive.
Incentive Application and required documents must be postmarked within 90 days of the work completed date. Please allow six weeks plus mail service time for delivery of your incentive check after your application and receipt has been received and approved. Missing information may delay processing and delivery of your incentive check. Checks are only payable to the account holder. Incentives are not to exceed the purchase price of the equipment or service. Equipment and service work may be inspected for compliance. Incentives are subject to tariff approval. Additional terms and conditions may apply.
You will need these items to apply online for your incentive:
- Rocky Mountain Power account number
- Electronic image of your receipt that shows the manufacturer name and model number of your new product
- Complete and submit your online application within 90 days of purchasing your new energy-efficient product
- Please allow six weeks plus mail service time for delivery of your incentive check after your application and receipt has been received and approved. Missing information may delay processing and delivery of your incentive check
- You can locate your account number on your statement as shown below
Have you already applied? Track your incentive status. Please allow 48 hours for your online application to load in our system.